Segway Drift W1 - Product Info - Segway-Ninebot.APAC

Specs

Segway Drift W1

General

Dimensions

Mainframe (single wheel):11.5×6.4×4.8 in (291×162×121 mm)
Unit:12.5×10.6×8.7 in (318×269×219 mm)
Payload: 22-220 lbs (10-100 kg)

Weight

Net (single wheel): Approx. 7.7 lbs (3.5 kg)

Rider

Recommended Age

6+ years old. See the weight limit

Machine Parameters

Max. Speed

Approx. 7.5 mph (12 km/h)
Top speed will vary based on riding style and remaining battery life.
Top speed will be reduced when the battery is low.

Typical Riding Time^[1]

45 minutes

Max. Slope^[2]

10°

Traversable Terrain

Flat, hard ground free of bumps or obstacles

Operating Temperature

14-104°F (-10-40°C)

Storage Temperature

-4-122°F (-20-50°C)

IP Rating

Mainframe IP54/ Battery pack IPX6

Max. Storage Time

Approx. 180 days/100% power; Approx. 30 days/30% power

Charge Time (for both mainframes)

Approx. 3 hours

Nominal Voltage

22.2 V⎓

Max. Charging Voltage

25.2 V⎓

Charging Temperature

32-104°F (0-40°C)

Battery

Nominal Capacity

44.4 Wh

Battery Management System

Over-voltage, under-voltage, over-current, short circuit, and over-heating protection.
Auto-sleep, auto-balance, and auto-wake.

Motor

Max. torque (single wheel)

6 Nm

Output Power

37.5 W

Charger

Input Voltage

100~240V~

Output Voltage

25 ± 0.2V⎓

Output Current

1.5A

[1] Typical Riding Time: Tested while riding under full power, 165 lbs (75 kg) load, 77°F (25°C),
5 mph (8 km/h) average speed on flat hard ground.

[2] Max. Slope: Tested while riding with the payload of 165 lbs (75 kg) and speed less than 3 mph (5km/h)

FAQ

Segway Drift W1

Troubleshooting

Re-Calibration

There is a very simple recalibration procedure that will reset your e-Skate.

Power off
Set the e-Skate upside down on a level surface

Power on
The unit will beep and the wheel will begin turning slowly in alternating directions

Power off
Set the e-Skate right side up

Power on
The e-Skate should be recalibrated and function properly

You may need to repeat this procedure multiple times to get a full calibration